Side by side

FANUC CRX-5iA vs Kawasaki CL105N

Two collaborative arms a buyer shopping for machine tending would honestly weigh against each other, with the manufacturer-published figures in one table and a plain reading of what the differences mean on a floor. We sell across brands, so we have no reason to tilt it.

	FANUC CRX-5iA	Kawasaki CL105N
Class	Collaborative arm	Collaborative arm
Payload	5 kg (11 lb)	5 kg (11 lb)
Reach	994 mm	800 mm
Sold as collaborative	yes	yes
Applications listed	machine tending, pick and place, packaging, material movement	machine tending, pick and place, assembly and screwdriving, inspection
Specs checked	2026-08-22	2026-08-22

Every figure is a manufacturer-published claim, checked on the date shown against the maker's own material, and not one of them survives contact with your part, your rate and your floor without an applications review. Prices are deliberately absent: quotes are prepared by our team and confirmed with the manufacturer.

What the numbers mean on the floor

Payload is effectively a tie at 5 kg and 5 kg. The gripper and the part decide it, not the arm: rated payload is measured at the wrist with no tool on it.
The FANUC CRX-5iA reaches 194 mm farther than the Kawasaki CL105N. That matters for pallet height, bin depth and machine door clearance more than it matters at a bench.
Both are sold as collaborative. That describes a feature set, not a safety verdict: the risk assessment on your part, your gripper and your speed is what decides whether anyone works beside it. Collaborative does not mean fenceless.
Both are listed for machine tending, pick and place. The FANUC CRX-5iA is also listed for packaging, material movement. The Kawasaki CL105N is also listed for assembly and screwdriving, inspection.

What a spec sheet cannot tell you

The gripper, the fixture and the integrator decide more of the outcome than the arm. Cycle time on your part is a test, not a datasheet figure. Service footprint, spare parts and who answers the phone at 2 AM differ by brand and by state. And the price difference between two arms in the same class is usually smaller than the difference between two integrators' quotes for the same cell. A model number is not a specification, and the gripper is the project.

From our matrix

FANUC CRX-5iA. IP67 body and wrist; 1000 mm/s collaborative, 2000 mm/s in high speed mode.

Kawasaki CL105N. Name encodes 5 kg payload, not 105 kg. 800 mm reach; IP66.

Also on the shortlist for machine tending

Ask about these two for your job

Free, about two minutes, no phone number. Joe will tell you which belongs on your shortlist, what beats both, and what has to be true for the math to work.