Side by side
Doosan H2515 vs FANUC CRX-25iA
Two collaborative arms a buyer shopping for machine tending would honestly weigh against each other, with the manufacturer-published figures in one table and a plain reading of what the differences mean on a floor. We sell across brands, so we have no reason to tilt it.
| Doosan H2515 | FANUC CRX-25iA | |
|---|---|---|
| Class | Collaborative arm | Collaborative arm |
| Payload | 25 kg (55 lb) | 25 kg (55 lb) |
| Reach | 1500 mm | 1889 mm |
| Sold as collaborative | yes | yes |
| Applications listed | palletizing, machine tending, material movement | palletizing, material movement, machine tending, welding |
| Specs checked | 2026-08-22 | 2026-08-22 |
Every figure is a manufacturer-published claim, checked on the date shown against the maker's own material, and not one of them survives contact with your part, your rate and your floor without an applications review. Prices are deliberately absent: quotes are prepared by our team and confirmed with the manufacturer.
What the numbers mean on the floor
- Payload is effectively a tie at 25 kg and 25 kg. The gripper and the part decide it, not the arm: rated payload is measured at the wrist with no tool on it.
- The FANUC CRX-25iA reaches 389 mm farther than the Doosan H2515. That matters for pallet height, bin depth and machine door clearance more than it matters at a bench.
- Both are sold as collaborative. That describes a feature set, not a safety verdict: the risk assessment on your part, your gripper and your speed is what decides whether anyone works beside it. Collaborative does not mean fenceless.
- Both are listed for machine tending, material movement, palletizing. The FANUC CRX-25iA is also listed for welding.
What a spec sheet cannot tell you
The gripper, the fixture and the integrator decide more of the outcome than the arm. Cycle time on your part is a test, not a datasheet figure. Service footprint, spare parts and who answers the phone at 2 AM differ by brand and by state. And the price difference between two arms in the same class is usually smaller than the difference between two integrators' quotes for the same cell. A model number is not a specification, and the gripper is the project.
From our matrix
Doosan H2515. Heavy payload H series; Doosan states no uplift condition for H models.
FANUC CRX-25iA. Discontinued, replaced by the CRX-30iA. 1889 mm at 25 kg, restricted to 1756 mm at 30 kg.
Also on the shortlist for machine tending
- Doosan H and M series, 25 kg
- Techman TM25S, 25 kg
- Kassow Robots KR1824, 24 kg
- AUBO AUBO-i20, 20 kg
- Dobot CR20A, 20 kg
Ask about these two for your job
Free, about two minutes, no phone number. Joe will tell you which belongs on your shortlist, what beats both, and what has to be true for the math to work.