Side by side
Dobot CR10A vs Doosan M1013
Two collaborative arms a buyer shopping for machine tending would honestly weigh against each other, with the manufacturer-published figures in one table and a plain reading of what the differences mean on a floor. We sell across brands, so we have no reason to tilt it.
| Dobot CR10A | Doosan M1013 | |
|---|---|---|
| Class | Collaborative arm | Collaborative arm |
| Payload | 10 kg (22 lb) | 10 kg (22 lb) |
| Reach | 1300 mm | 1300 mm |
| Sold as collaborative | yes | yes |
| Applications listed | machine tending, packaging, pick and place, sanding and finishing | machine tending, welding, pick and place |
| Specs checked | 2026-08-22 | 2026-08-22 |
Every figure is a manufacturer-published claim, checked on the date shown against the maker's own material, and not one of them survives contact with your part, your rate and your floor without an applications review. Prices are deliberately absent: quotes are prepared by our team and confirmed with the manufacturer.
What the numbers mean on the floor
- Payload is effectively a tie at 10 kg and 10 kg. The gripper and the part decide it, not the arm: rated payload is measured at the wrist with no tool on it.
- Reach is close, 1300 mm against 1300 mm. Neither will rescue a layout that puts the pick and the place too far apart.
- Both are sold as collaborative. That describes a feature set, not a safety verdict: the risk assessment on your part, your gripper and your speed is what decides whether anyone works beside it. Collaborative does not mean fenceless.
- Both are listed for machine tending, pick and place. The Dobot CR10A is also listed for packaging, sanding and finishing. The Doosan M1013 is also listed for welding.
What a spec sheet cannot tell you
The gripper, the fixture and the integrator decide more of the outcome than the arm. Cycle time on your part is a test, not a datasheet figure. Service footprint, spare parts and who answers the phone at 2 AM differ by brand and by state. And the price difference between two arms in the same class is usually smaller than the difference between two integrators' quotes for the same cell. A model number is not a specification, and the gripper is the project.
From our matrix
Dobot CR10A. Covers most standard machine tending cells.
Doosan M1013. Up to 12 kg via automatic acceleration adjustment per Doosan catalog footnote.
Also on the shortlist for machine tending
- ABB GoFa CRB 15000-10/1.52, 10 kg
- ABB SWIFTI CRB 1300-10/1.15, 10 kg
- AUBO AUBO-i10, 10 kg
- FANUC CRX-10iA, 10 kg
- FANUC CRX-10iA/L, 10 kg
Ask about these two for your job
Free, about two minutes, no phone number. Joe will tell you which belongs on your shortlist, what beats both, and what has to be true for the math to work.